Skip to main content
Fig. 3 | 3D Printing in Medicine

Fig. 3

From: On the optimization of low-cost FDM 3D printers for accurate replication of patient-specific abdominal aortic aneurysm geometry

Fig. 3

3D printed rings with 2 mm wall thickness for the application of AAA modelling. a and b The 3D printed rings are flexible. c Rings printed with 30, 40, 50 and 60 mm/s printing speeds (see Additional file 1: Table S7 in the Appendix for the rest of the printing parameters) had fair transparency and a noticeable join line that was constant throughout all prints

Back to article page

3D Printing in Medicine

ISSN: 2365-6271

Contact us