Skip to main content
Fig. 9 | 3D Printing in Medicine

Fig. 9

From: DICOM segmentation and STL creation for 3D printing: a process and software package comparison for osseous anatomy

Fig. 9

Comparison of the STL model of MCS (d) and VE3 (e), which showed the largest shape error between any two STL models. Visualization of the shape error (signed differences) after superimposition is shown on the right (f). The whole mandible is depicted as green to yellow (shape error range of approximately 0.0 mm - 0.5 mm), with occasional orange to red parts. The mean shape error was 0.27 mm (maximum + 0.80 mm, minimum − 0.81 mm)

Back to article page