Table 1 Summaries the printing settings for the produced masks. PLA; Polylactic acid, TPU; Thermoplastic Polyurethane, mm; millimeter, s; second
Mask type | TPU mask | PLA mask |
|---|---|---|
Printing parameters | • Printing parameters: Same print parameter in the preloaded fine print profile in Cura 4.11.0 slicing software. Which are as follow: - Wall thickness 1.05 mm. - Top/bottom thickness 1.2 mm. - 10% infill density with grid pattern. - Print speed at 40 mm/s. - Everywhere support with overhang angle of 45 degrees. | • Printing parameters: Same print parameter in the preloaded fine print profile in Cura 4.11.0 slicing software. Which are as follow: - Wall thickness 1.05 mm. - Top/bottom thickness 0.8 mm. - 20% infill density with grid pattern. - Print speed at 50 mm/s. - Everywhere support with overhang angle of 50 degrees. |