Skip to main content
Fig. 1 | 3D Printing in Medicine

Fig. 1

From: Measured and simulated mechanical properties of additively manufactured matrix-inclusion multimaterials fabricated by material jetting

Fig. 1

Left: Drawing of the specimen with inclusions. During the measurements, it was loaded in X-direction. A layer from the center was cut out and used for simulation as shown on the right side. Right: Render of the simulated layer with \(10\times 4\) inclusions. The bottom side is fixated in X direction and the upper surface is displaced to reach a strain of \(\varepsilon =0.25\%\)

Back to article page

3D Printing in Medicine

ISSN: 2365-6271

Contact us